38mm Floating Closure Tapped

38mm Floating Forward Closure Tapped(anchor Point), requires the use of 38mm retaining ring, item 1413

38mm Floating Forward Closure

38mm Floating Forward Closure, requires the use of 38mm retaining ring, item 1413 or item 804

Aerotech 38/120-720 Combo

38/120-720 Combo include a 38/360 case, 38/720 case, aft closure, seal disk, and the 38mm RAS(Reload Adapter System)

Aerotech 38/240 Complete Motor Hardware

Includes forward closure, aft closure, and motor casing

Aerotech 38mm 240 Motor Case Only

Includes motor casing only

Aerotech 38mm Aft Closure

38mm Aft Closure

Aerotech 38mm Forward Closure Retaining Ring

38mm Forward Closure Retaining R

Aerotech 38mm Forward Closure Ring with Anchor

The anchor retaining ring (P/N 38FCRRA) for the AeroTech 38mm RMS™ reload adapter system is now available. The new retaining ring has a central 5/16-18 thread for a forged eyebolt or similar recovery attachment and is vented to allow passage of ejection charge gases. The anchor retaining ring can only be used with the reload adapter system when one or more case spacers are present in the motor assembly. The 38mm AeroTech RMS reload adapter system allows the use of shorter (lower power) RMS …

Aerotech 38mm Forward Closure Standard

38mm Forward Closure Standard

Aerotech 38mm Forward Closure Tapped Plugged

38mm Fwd Closure Tapped Plugged

Aerotech 38mm Reload Adapter System

38mm Reload Adapter System includes (2) 38mm Case Spacers (38FCCS), (1) Floating Forward Closure (38FFC) and (1) 38mm Forward Closure Retaining Ring (38FCRR)

Aerotech Rocket Delay Drilling Tool RDDT

The RMS Delay Drilling Tool™ (or RDDT™, P/N T082510-1) is designed for shortening RMS and RMS-Plus delay elements to adjust the time delay of an AeroTech RMS reloadable motor. This tool is a “stand-alone” unit and replaces the Delay Drilling Adapter™ (P/N T062705-1) which is being discontinued. The RDDT consists of a machined drill tool body and a 1/4” stub drill bit with an attached knob. The tool also has a provision for calibration, as the tip of the drill bit must be flush with t…